Product Description:

The MDD071C-N-060-N2T-095GA2 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is intended for use with digital drive controllers, where it converts commanded current into precise rotational movement for pick-and-place arms, material feeders, and indexing tables. The compact construction lets it fit close to working axes, which helps in dense machine layouts with limited installation space. This motor is suited for automated equipment that requires repeatable motion during frequent start-stop cycles.

For mechanical alignment, the motor flange uses a 95 mm centering diameter, and the rotor follows standard balancing so vibration remains low across the speed range. At standstill, it delivers 6.6 Nm of continuous torque, allowing static load holding without thermal overload during controlled dwell periods. An integrated multi-turn absolute encoder reports position across many revolutions, so the controller can resume operation without a homing routine after power returns. The shaft can reach 6000 rpm, giving a wide operating range for processes that alternate between slow positioning and rapid traverses. When power is removed, a built-in blocking brake supplies 6.5 Nm of holding torque to secure the axis.

All electrical power, brake, and feedback leads exit on side A through a single keyed connector, which helps keep cable routing orderly inside tight cabinets and compact machine frames. Motion feedback is transmitted as digital servo feedback, so the controller receives position data without separate external transducers. The motor uses a plain shaft on the drive side only, which reduces overall length by omitting a second shaft end. A shaft seal is fitted to help keep coolant and dust away from the bearings, and the size 071 housing with length code C supports compact gantry and feeder installations.