Product Description:

The MDD071C-N-060-N2S-095GL0 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts controlled electrical input into precise rotary motion for positioning and speed-regulated tasks on automated machinery and assembly stations. Its compact 071 frame size and standard housing design allow direct integration into multi-axis modules where high rotational speed and accurate feedback are required.

This model delivers a continuous stall torque of 6.6 Nm, giving machinery a stable output when the rotor is energized but motionless. A nominal speed of 6000 rpm lets the drive maintain fast cycle times without exceeding thermal limits. Accurate mechanical alignment is supported by a 95 mm centering diameter, which matches common flange patterns in the series. Power and feedback conductors exit through a connection on the left side by means of a sealed industrial connector, which helps simplify cable routing in compact cabinets. Position data is returned through digital servo feedback, so the controller can close the velocity and position loops at high resolution. Rotor mass is kept low for responsive motion, and the assembly uses standard balancing to reduce vibration transfer into bearings and mounting plates. The motor is supplied without a blocking brake, and its standard housing preserves natural convection paths around the windings.

The mechanical interface uses a plain shaft that fits keyed or friction-fit couplings, and it comes with a shaft seal to help prevent lubricant migration and dust ingress. The design uses length code C, which gives the rotor a longer active stack than shorter variants without changing the 071 flange. A single-ended shaft configuration on side A leaves room for the encoder. The absence of a side B shaft extension helps reduce installation depth in narrow drive trains, and the standard connector keeps cable access straightforward.