MDD071C-N-060-N2S-095GA1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911274763
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
31 Seconds
The Bosch Rexroth Indramat MDD071C-N-060-N2S-095GA1 is a motor designed for digital drive controllers and is part of the MDD Synchronous Motors series. It features a 6.6 Nm continuous torque at standstill, a plain shaft with shaft seal, and a centering diameter of 95 mm. This motor has a nominal speed of 6000 rpm and comes with digital servo feedback and a holding brake that provides 3.0 Nm of torque.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD071C-N-060-N2S-095GA1 is a brushless synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Intended for use with digital drive controllers, it converts controlled current into precise rotary motion for automated transfer lines, packaging modules, and other industrial axes. Permanent-magnet excitation and integrated feedback allow the motor to supply tightly regulated torque and speed profiles that suit demanding positioning tasks in factory environments. This operating principle supports repeatable starts, stops, and speed changes in machines that depend on accurate axis response during cyclic motion. Because feedback is integrated into the motor, the drive can monitor rotor behavior directly and correct small speed deviations before they affect product handling or transfer accuracy.
Its nominal speed reaches 6000 rpm, which is the upper mechanical limit during continuous operation. At standstill the rotor can exert 6.6 Nm without duty-cycle restrictions, so vertical loads can remain supported without overheating. The flange centering diameter measures 95 mm for repeatable concentric alignment. All power and feedback conductors exit on side A, where a sealed connector keeps cable routing compact. Standard dynamic balancing helps reduce vibration during high-speed running, and the C length code indicates the longest stator stack available in this frame. The standard housing also maintains envelope dimensions compatible with earlier MDD designs, which helps when the motor is installed in existing machine layouts.
A blocking brake rated at 3.0 Nm clamps the rotor when power is removed, preventing back-drive on suspended loads. Motion data is returned through digital servo feedback (DSF), giving the controller high-resolution speed and position information for closed-loop control. The output uses a plain shaft with a shaft seal, which supports direct coupling while helping keep lubricant in and contaminants out during washdown cycles. The motor has a single shaft end on the drive side, and motor size 071 keeps the package compact enough for tight installation spaces. This arrangement suits machines that need high speed, stable feedback, and a built-in holding function without adding external braking hardware.
Frequently Asked Questions about MDD071C-N-060-N2S-095GA1:
Q: What is the continuous standstill torque of the MDD071C-N-060-N2S-095GA1 motor?
A: This model supplies a continuous torque of 6.6 Nm when at standstill.
Q: Does the MDD071C-N-060-N2S-095GA1 motor come with a holding brake?
A: A holding brake delivering 3.0 Nm of torque is included with this motor.
Q: What type of feedback system is equipped on the MDD071C-N-060-N2S-095GA1 motor?
A: This motor utilizes digital servo feedback (DSF) for position and speed monitoring.
Q: How is the MDD071C-N-060-N2S-095GA1 motor electrically connected?
A: The connection on this unit is positioned on Side A and uses a connector type interface.
Q: What is the nominal speed of the MDD071C-N-060-N2S-095GA1 synchronous motor?
A: The nominal speed for this motor is 6000 min⁻¹, allowing for high-speed operation.
