Product Description:

The MDD071C-N-060-N2S-095GA0 is an AC servo motor from Bosch Rexroth Indramat in the MDD Synchronous Motors series. It is intended for use with digital drive controllers, where regulated electrical commands are converted into precise rotary motion for industrial axes such as gantry stages and packaging conveyors. The motor is built as a compact actuator that works with Rexroth drive modules, allowing the control system to regulate velocity, torque, and position through electronic feedback. This arrangement supports accurate motion on automated equipment that requires stable response during repeated start, stop, and positioning cycles.

The motor uses a centering diameter of 95 mm, which supports accurate alignment during mounting to machine flanges or gear units. At standstill, it can deliver a continuous torque of 6.6 Nm, making it suitable for holding duties that require steady output without unstable thermal behavior. Its nominal operating speed reaches 6000 rpm, allowing fast movement on axes that benefit from high rotational speed. Power is transmitted through a plain shaft, which supports coupling arrangements that do not require a keyed shaft. Positional information is returned through digital servo feedback, giving the connected drive the signals needed for closed-loop motion control and consistent axis regulation during changing load conditions.

Electrical and service connections exit on Side A through a sealed connector, which helps keep cable routing organized near the motor connection point. The motor has length code C, which indicates a longer stack within this frame family, and it is built in size 071 for a compact installation envelope. A fitted shaft seal helps limit the entry of contaminants in demanding installation areas. The housing is supplied in a standard version, and the motor comes without a blocking brake. Its single-ended design leaves the rear face without a second shaft extension, which can simplify integration where rear-side mechanical output is not needed.