MDD071C-N-040-N2T-095GA1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911268279
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
46 Seconds
The Bosch Rexroth Indramat MDD071C-N-040-N2T-095GA1 is part of the MDD Synchronous Motors series and is designed for use with digital drive controllers. It provides a continuous torque at standstill of 6.6 Nm and a nominal speed of 4000 rpm, with a centering diameter of 95 mm. This motor features an integrated multiturn absolute encoder and a holding brake with a torque of 3.0 Nm.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD071C-N-040-N2T-095GA1 is a synchronous servo motor built by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts controlled electrical input into precise mechanical motion for automated axes, pick-and-place gantries, and similar industrial tasks. This makes it suitable for packaging machines, transfer units, and positioning stages that depend on accurate acceleration and repeatable stopping behavior. Its compact build, C-length frame, and size 071 allow integration into multi-axis assemblies where mounting space is limited, while the standard housing and balancing support consistent installation in established drive systems.
During stationary holding conditions, the motor can deliver a continuous torque of 6.6 Nm, enabling stable load support without overheating. A nominal speed of 4000 rpm permits rapid indexing cycles when paired with suitable drive electronics. Position feedback is generated by an integrated multi-turn absolute encoder, so the system can retain position over multiple revolutions after power is removed. Closed-loop feedback is transmitted through digital servo feedback (DSF), giving the controller high-resolution velocity and position data. Mechanical alignment in the machine frame is centered by a 95 mm centering diameter, which helps maintain repeatable concentricity between the stator flange and adjoining mounts.
A blocking brake rated at 3.0 Nm secures vertical loads during stopping and holding, and it is factory installed so no external brake assembly is needed. Power and feedback conductors exit on Side A through a keyed Connector, which helps keep cable routing organized and reduces the chance of mismatched connections. The drive end uses a plain shaft with a fitted shaft seal to limit lubricant escape and the entry of particulates. The opposite end is closed, following the standard single-ended shaft arrangement used on this motor design. This layout supports direct coupling to common machine elements while helping protect internal bearing areas from contamination in normal industrial service.
Frequently Asked Questions about MDD071C-N-040-N2T-095GA1:
Q: What type of encoder is included in the MDD071C-N-040-N2T-095GA1 motor?
A: This model features an integrated multiturn absolute encoder for precise position measurement.
Q: What is the holding brake torque of the MDD071C-N-040-N2T-095GA1?
A: The holding brake on this motor provides a torque of 3.0 Nm.
Q: What shaft configuration does the MDD071C-N-040-N2T-095GA1 have?
A: A standard plain shaft design is featured, without a side B shaft end.
Q: What is the nominal speed capability of the MDD071C-N-040-N2T-095GA1 motor?
A: The maximum nominal speed for this motor is 4000 min⁻¹.
Q: What is the continuous torque at standstill for the MDD071C-N-040-N2T-095GA1?
A: This motor provides a continuous torque of 6.6 Nm at standstill.
