Product Description:

The MDD071C-N-040-N2S-095GR1 is a synchronous motor in the MDD Synchronous Motors series and is intended for use with digital drive controllers in automated production lines. In these systems, the motor converts commanded current into controlled rotary motion for packaging axes, pick-and-place heads, and other positioning tasks that require repeatable movement. It is suited to applications where stable speed control and accurate axis response are needed during frequent starts, stops, and direction changes. In multi-axis equipment, it supports smooth transitions between acceleration, constant-speed travel, and stopping phases without requiring a large installation envelope.

The motor can provide a continuous standstill torque of 6.6 Nm, and it reaches a nominal speed of 4000 rpm for fast operating cycles. Accurate mounting is supported by a centering diameter of 95 mm, and an internal blocking brake supplies 3.0 Nm of holding torque when drive power is removed. Motion feedback is handled through digital servo feedback (DSF), which gives the controller the information needed for closed-loop position and speed regulation. This feedback arrangement helps the drive correct speed variation as load conditions change during indexing and transfer movements. A right-side connector orientation and a keyed circular connector also help keep cable routing orderly inside compact machine frames.

A shaft seal helps protect the bearing area, and the motor uses a plain shaft for torque transmission. The housing is built in size 071 with length code C, which keeps the package compact while supporting medium-duty servo use. The rotor uses standard balancing quality, which helps limit vibration when the motor is connected to rigid couplings or other direct-drive elements. There is no secondary shaft extension on side B, leaving a simpler output arrangement where space around guards, couplings, and adjacent machine parts is limited.