MDD071C-N-040-N2S-095GA1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911264404
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
37 Seconds
The Bosch Rexroth Indramat MDD071C-N-040-N2S-095GA1 is part of the MDD Synchronous Motors series and is designed for digital drive controllers. It features a nominal speed of 4000 rpm and provides a continuous torque at standstill of 6.6 Nm. The motor includes a 95 mm centering diameter, a plain shaft with shaft seal, and a holding brake with 3.0 Nm torque.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD071C-N-040-N2S-095GA1 servo motor from Bosch Rexroth Indramat is part of the MDD Synchronous Motors series. Designed as a motor for digital drive controllers, it converts electrical command signals into precise rotational motion for automated axes in packaging lines, pick-and-place gantries, and similar equipment. By integrating position feedback and a blocking brake inside a compact frame, the motor supports quick positioning and secure load holding within multi-axis CNC or material-handling systems. This arrangement lets the paired controller correct speed and position deviations during acceleration, indexing, and settling.
At a continuous standstill torque of 6.6 Nm, the rotor can hold load without exceeding its thermal limit when motion is halted. Once energized, the motor reaches a nominal speed of 4000 rpm, allowing high cycle rates with synchronous accuracy. A built-in blocking brake delivers 3.0 Nm of static torque to secure vertical loads during power-off events. The centering diameter is 95 mm, which aligns the flange with the machine frame and keeps the motor concentric during mounting. Dynamic servo feedback is handled through digital servo feedback, giving the drive controller position data for precise closed-loop operation. The motor uses standard balancing, and the C length code indicates an extended active stack for higher torque density than shorter lengths. The brake and feedback system also support controlled stopping and accurate restart behavior after interruptions.
Electrical and signal terminations use a connector positioned on side A, so cables exit toward the drive cabinet without crossing adjacent machinery. This routing can help keep power and feedback leads clear of moving tooling and nearby guards. A fitted shaft seal helps block contaminants at the shaft opening, and the plain shaft is provided only on the drive side to simplify coupling with pinions or pulleys. The motor housing dissipates heat through natural convection, and the standard shaft end omits any extension on side B to reduce overall length.
Frequently Asked Questions about MDD071C-N-040-N2S-095GA1:
Q: What is the continuous torque at standstill for the MDD071C-N-040-N2S-095GA1 servo motor?
A: This model features a continuous torque at standstill of 6.6 Nm.
Q: What is the holding brake torque for this motor?
A: The MDD071C-N-040-N2S-095GA1 has a holding brake with a torque of 3.0 Nm.
Q: What type of motor feedback does the MDD071C-N-040-N2S-095GA1 use?
A: This motor provides digital servo feedback (DSF) for position detection.
Q: What type of shaft and sealing is included with this servo motor?
A: The shaft on this unit is a plain shaft with a shaft seal for additional protection.
Q: Where is the connection located and what type does the MDD071C-N-040-N2S-095GA1 use?
A: Connection is established via a connector on Side A.
