Product Description:

The MDD071C-N-030-N2S-095PR2 is a servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for pairing with digital drive controllers, it converts electrical power into precise rotary motion for positioning tasks, conveyor sections, and general automation axes. Its integrated position feedback and preloaded bearings support closed-loop velocity and torque regulation across a broad duty cycle. The housing format is intended for industrial machinery where accurate response and steady servo behavior are required during repeated cycling. This operating profile suits equipment that must perform frequent starts, stops, and speed changes without losing positional consistency.

At the mechanical interface, the motor supplies a continuous standstill torque of 6.6 Nm, giving the drive enough margin to hold or accelerate loads without external gearing. At rated electrical frequency, it reaches a nominal speed of 3000 rpm, which suits many packaging spindles and indexing tables. Installation is centered on a 95 mm pilot, so the flange mates directly to standardized machine frames without shims. Rotary position is reported through digital servo feedback (DSF), enabling the drive controller to close loops with high resolution and compensate for load fluctuations in real time. Standard dynamic balancing reduces vibration when the rotor tracks rapid speed changes.

The built-in blocking brake exerts 6.5 Nm of static torque, keeping vertical or suspended loads motionless once power is removed. Power and feedback cables exit on the right side, and a coded connector allows connection without rewiring terminal strips. The output shaft uses a keyway, and a shaft seal helps prevent lubricant migration toward the feedback chamber. The motor has length designation C, which corresponds to the stator stack used for this housing size. It can be fitted where the MDD signal format and mounting dimensions are already used on the machine.