MDD071C-N-030-N2S-095PB1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911265918
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
4 Minutes
2 Seconds
The Bosch Rexroth Indramat MDD071C-N-030-N2S-095PB1 is part of the MDD Synchronous Motors series and is designed for digital drive controllers. This motor has a continuous torque of 6.6 Nm at standstill and a nominal speed of 3000 per minute. It features digital servo feedback, a 95 mm centering diameter, a side B connector, and includes a blocking brake with 3.0 Nm holding torque.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD071C-N-030-N2S-095PB1 is a synchronous servo motor built by Bosch Rexroth Indramat within the MDD Synchronous Motors series. It is used with digital drive controllers in industrial automation systems. The motor converts electrical command signals into controlled rotary motion for axes such as packaging stations, pick-and-place modules, or indexing tables.
The mechanical interface starts with a centering diameter of 95 mm, allowing the frame to align precisely with geared reducers or flange plates. Balancing is standard, so vibration levels remain within normal limits across the speed range. The unit offers a compact profile while preserving thermal mass. When stalled under rated current, it produces 6.6 Nm of continuous torque, giving adequate holding force for moderate-load axes. The rotor can accelerate to a nominal speed of 3000 rpm, letting the drive follow high-cycle commands. All power and sensor conductors exit on side B through a keyed connector, which helps simplify cable routing in tight cabinets. Position and speed are reported through integrated digital servo feedback, enabling closed-loop regulation by the associated controller. A standard housing encloses these elements and maintains ingress protection around the stator.
A permanent-magnet blocking brake is factory-installed, and it supplies 3.0 Nm of static torque to hold vertical loads whenever the drive is disabled. The brake sits on the same shaft that uses a keyway for positive locking with pulleys or couplings. A shaft seal helps protect the internal bearings against fluid ingress, and the shaft is supplied only on the drive side, leaving the opposite face blank to simplify mounting. Length code C keeps the body short enough for multi-axis clusters while still providing space for heat dissipation during continuous stall operation.
Frequently Asked Questions about MDD071C-N-030-N2S-095PB1:
Q: What is the continuous torque at standstill for the MDD071C-N-030-N2S-095PB1 motor?
A: This motor provides a continuous torque of 6.6 Nm at standstill, allowing for steady and reliable performance under load.
Q: What is the holding brake torque on the MDD071C-N-030-N2S-095PB1 synchronous motor?
A: The MDD071C-N-030-N2S-095PB1 features a holding brake with a torque of 3.0 Nm.
Q: What type of motor feedback does the MDD071C-N-030-N2S-095PB1 have?
A: The motor uses digital servo feedback (DSF) for position and motion control accuracy.
Q: What is the nominal speed for the Bosch Rexroth Indramat MDD071C-N-030-N2S-095PB1 motor?
A: The nominal speed of this model is set at 3000 min⁻¹.
Q: What shaft features are included on the MDD071C-N-030-N2S-095PB1 motor?
A: It comes with a keyway shaft type and a shaft seal for added protection.
