Product Description:

The MDD071C-N-030-N2S-095GB2 is a synchronous servo motor produced by Bosch Rexroth Indramat and supplied within the MDD Synchronous Motors series. As a motor intended for digital drive controllers, it converts controlled electrical power into rotational motion for positioning and velocity tasks on automated axes throughout factory machinery. In automated equipment, it can be used on feed axes, indexing units, and handling motions that depend on repeatable servo response. Its synchronous design supports accurate speed regulation and predictable motion during frequent starts, stops, and direction changes.

This model can sustain a continuous shaft torque of 6.6 Nm without overheating, providing stable output during static or low-speed operation. Under rated electrical excitation, it reaches a nominal speed of 3000 rpm, which suits many general-purpose servo axes. A built-in blocking brake supplies 6.5 Nm of holding torque so vertical or suspended loads remain stationary when power is removed. Mechanical alignment is simplified by the 95 mm centering diameter, which locates the stator housing on precision machine frames. Power and feedback conductors exit in the Side B connection direction, which is useful when cable routing must run toward the rear of a machine bed. This layout can also help keep cable bends away from nearby guards or mounting plates.

A shaft seal helps prevent lubricant migration and supports IP65 protection in dusty or wet environments. Position data is returned through digital servo feedback, allowing closed-loop commutation and speed control without a separate external encoder. The rotor is balanced to the Standard grade to reduce vibration during direct coupling to precision loads. The motor uses size code 071 for a frame envelope that fits compatible Rexroth drive flanges and gearheads. This frame size is suited to machine axes where compact mounting space and controlled servo motion are both important.