Product Description:

The MDD071A-N-060-N2T-095GA0 is a synchronous servo motor from Bosch Rexroth Indramat in the MDD Synchronous Motors series. It is built to operate with digital drive controllers and to deliver controlled torque and speed to assembly equipment, pick-and-place units, and similar automated axes. Its electromechanical layout converts commanded current into rotary motion with very little delay. This makes it suitable for repetitive positioning tasks where fast response and stable velocity control are required over many operating cycles.

Mechanical alignment is set by the 95 mm centering diameter, which helps keep the motor concentric with the machine flange. At standstill, it provides 2.2 Nm of continuous torque, and it reaches 6000 rpm during high-speed operation. Position data is supplied by an integrated multi-turn absolute encoder and carried through digital servo feedback (DSF), so the connected drive receives continuous rotor information for closed-loop control. The encoder arrangement also lets the drive retain absolute shaft position information after power is restored. The compact size 071 with length code A helps reduce moving mass on smaller axes, and the standard balance grade supports smooth rotation across changing load conditions.

Power and feedback cables terminate in a connector on side A, which keeps both cable runs on the same end of the housing and simplifies routing in tight machine spaces. Single-end cable entry can also reduce cable crossover near neighboring axes or guarding panels. The output uses a plain shaft without keyways, making it suitable for clamp-style hubs or press-fit transmission elements that need uniform contact around the shaft surface. The motor is supplied without a blocking brake, so any holding force at zero speed must come from the drive or from an external mechanical device. A shaft seal protects the bearing area, and the standard housing finish is appropriate for common industrial indoor installations.