Product Description:

The MDD071A-N-060-N2S-095PR1 is a synchronous servo motor produced by Bosch Rexroth Indramat for use with digital drive controllers in the MDD Synchronous Motors series. Designed as a compact rotary actuator for industrial automation, it converts electrical command signals from the drive into controlled mechanical motion. The motor responds quickly to drive commands, making it suitable for closed-loop speed and position control in packaging stations, handling modules, and similar axes. Its compact format also suits installations where space is limited but accurate and repeatable motion is still required.

The motor’s centering shoulder measures 95 mm, allowing precise alignment in standard machine mounts without shims. At a nominal speed of 6000 rpm, the rotor supports rapid-cycle operation, and the stator can sustain a standstill torque of 2.2 Nm within its thermal limits. A blocking brake inside the housing supplies 3.0 Nm of holding torque to secure vertical loads when power is off. Signal integrity to the controller is maintained by integrated digital servo feedback, and a shaft seal helps reduce lubricant leakage and particle entry during continuous production. This combination supports applications that must accelerate, stop, and hold position reliably through repeated operating cycles.

The rotor conforms to the 071 frame diameter, and its short stator body follows the A length code, which helps keep moving mass low for quick acceleration. Power reaches the load through a keyway shaft, and the single-ended design on side A avoids the need for an output extension on the opposite end. Standard dynamic balancing helps keep vibration low during continuous operation, which supports smooth running and steady bearing behavior. Power and feedback cables route through a single molded connector on the right-hand face, keeping the connection point compact and easy to align with machine-side cable routing.