Product Description:

The MDD071A-N-060-N2S-095GR1 is a servo motor manufactured by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. As a motor for digital drive controllers, it provides closed-loop rotary actuation that works with the drive’s position and velocity regulators in industrial automation cells. The unit is intended to deliver consistent speed and torque in compact handling stations, conveyor modules, or tool heads where fast response and repeatable motion are required. Its compact format also suits installations where available mounting space is limited but accurate axis control is still necessary.

Its nominal speed reaches 6000 rpm, so the controller can command high rotational rates without exceeding the motor’s intended operating range. At standstill, it supplies a continuous torque of 2.2 Nm, allowing stable holding or low-speed feed motion under thermal equilibrium. An electrically released blocking brake adds a holding capacity of 3.0 Nm for power-off retention. The centering shoulder measures 95 mm in diameter, providing alignment on machine frames that follow ISO flange patterns. Position information is returned through digital servo feedback, enabling the drive to correct load disturbances with minimal latency.

Power and signal plugs face the operator side because the connection orientation is Right, reducing bend radius on short cable sets. The rotor uses a plain shaft and does not include a side-B shaft extension, which supports direct coupling in compact machine layouts. A shaft seal is fitted to help keep coolant splash or dust away from the bearings during operation. Frame code 071 identifies the stator size used for this motor, while standard balancing and a single-piece housing help reduce vibration and support stable mounting through the integral connector interface.