Product Description:

The MDD071A-N-060-N2S-095GR0 belongs to the MDD Synchronous Motors series from Bosch Rexroth Indramat. As a motor for digital drive controllers, it supports closed-loop positioning and velocity control in automated machinery that requires compact dimensions and quick response. A standard-balanced rotor and a standard housing help the unit fit cleanly into multi-axis assemblies. This layout is commonly used on packaging, transfer, and handling axes that need repeatable motion without a large motor envelope.

The motor provides a continuous standstill torque of 2.2 Nm, which allows it to hold load at zero speed within its thermal limits. When energized by a matching controller, the rotor reaches a nominal speed of 6000 rpm for fast indexing and short cycle times. Position reference is returned through digital servo feedback, allowing the drive to correct following error during motion. Mounting accuracy is supported by a 95 mm centering diameter, and the output uses a plain shaft for direct coupling to pulleys or flexible couplings. Its short body length also helps conserve installation depth in compact machine sections.

Cabling exits on the right side of the stator housing, and both power and feedback leads terminate at a keyed connector for orderly routing. A shaft seal helps keep coolant mist and dust away from internal bearing areas during normal machine operation. Because the motor is supplied without a blocking brake, any load holding must be provided externally or by controlled drive torque. The single-ended shaft arrangement leaves the rear side free of an additional extension, which can simplify coupling alignment and reduce overhung mass. The standard housing finish and compatibility with the KD line of drives support use in machine modules with a common electrical platform.