Product Description:

The MDD071A-N-060-N2S-095GL2 servo motor is produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It functions as a motor for digital drive controllers, turning regulated three-phase current into controlled rotation for automated pick-and-place stations, indexing tables, and similar equipment. Within an automation cell, it provides rapid acceleration, accurate positioning, and secure holding through its integrated brake and internal feedback interface. This makes it suitable for axes that must start, stop, and hold position repeatedly during normal machine cycles.

At standstill, the rotor delivers 2.2 Nm of continuous torque, which reflects the load the stator windings can sustain thermally. Under rated excitation, the shaft can spin at 6000 rpm, supporting high surface speeds when demanded by the drive program. The electrically released brake applies 6.5 Nm of holding force to prevent back-driving during shutdowns. A flange pilot of 95 mm centers the housing so concentricity is maintained with gearheads or machine frames. Position data travel over Digital servo feedback (DSF), enabling the controller to register incremental movement and correct for deviations in real time during speed and position control.

Overall mechanical integrity is supported by standard balancing, which minimizes residual unbalance over the speed range. All power and feedback ports sit on the left side, simplifying access in cabinets that open from the right. Frame size code 071 reduces mass while retaining a usable torque envelope, and the compact A length keeps axial space consumption low. The motor is supplied with a shaft seal to block coolant or dust from entering the front bearing. Its plain shaft profile mates directly with clamp couplings or timing-belt pulleys, and the side-mounted connections help when clearance is limited beside the motor.