Product Description:

The Bosch Rexroth Indramat MDD071A-N-030-N2T-095GL2 is a synchronous servo motor from the MDD Synchronous Motors series. It operates as an electromechanical actuator that receives commands from a digital drive controller and converts them into precise rotary motion for automated equipment. Typical duties include pick-and-place axes, compact conveyors, and light tooling spindles that require stable speed, accurate positioning, and quick torque response. Because it is intended for use with a digital drive controller, the motor supports responsive speed and position control in compact automation stations. Its integrated feedback and brake allow direct installation in tight spaces without added external components.

At a nominal speed of 3000 rpm, the rotor supports medium-duty operating cycles, while a continuous standstill torque of 2.2 Nm allows the motor to hold load without excessive heating. A blocking brake provides 6.5 Nm of static torque to secure vertical or suspended loads when power is removed. Accurate flange alignment is supported by a 95 mm centering diameter, and standard balancing helps limit residual vibration during operation. Position data is supplied by an integrated multi-turn absolute encoder that retains position information after power loss. This combination supports axes that pause often but still need controlled restart behavior.

Closed-loop operation is supported by Digital servo feedback (DSF), so no external feedback device is required. Cables exit on the left side, which helps when clearance is limited on the right side of the machine. Mechanical output is transmitted through a plain shaft with a shaft seal, and the motor does not use a side-B shaft extension. Power and signal conductors terminate on a single connector, which keeps the external connection arrangement compact. The compact motor size 071 frame with A-length housing helps the unit fit into space-limited axes, and the housing uses the standard enclosure format used throughout the series.