Product Description:

The MDD071A-N-030-N2S-095GL1 is an AC synchronous servo motor manufactured by Bosch Rexroth Indramat and included in the MDD Synchronous Motors series. Designed for digital drive controllers, it converts command currents into rotary motion for positioning and velocity loops in factory automation. Its housing, shaft interface, and internal feedback elements are optimized for tightly integrated axes on packaging machines, pick-and-place gantries, and similar equipment where compact drive modules are needed. The unit uses permanent-magnet excitation for fast torque rise and supports closed-loop operation with matching drive amplifiers. This design also supports consistent torque response during frequent start and stop cycles.

This motor reaches a nominal speed of 3000 rpm, allowing the drive system to achieve moderate feed rates without mechanical gearing. At standstill, it supplies 2.2 Nm of continuous torque, so it can support static loads while remaining within its thermal limits. When the integrated blocking brake is energized, it can resist up to 3.0 Nm, helping secure vertical or suspended axes during power-off states. Position data is returned through digital servo feedback (DSF), which delivers high-resolution increments for precise commutation and error monitoring. The front flange has a 95 mm centering diameter that helps maintain concentricity between the motor and the adjoining machine structure. This combination supports precise low-speed holding as well as repeatable index moves.

Power and feedback connectors are mounted on the left side, simplifying wiring when the cabinet layout matches that orientation. The motor uses frame size 071, and the A length keeps overall depth minimal for short-stroke mechanisms. It has a plain shaft, and a shaft seal limits dust and coolant ingress. Dynamic balance is produced to a standard grade, and a sealed circular connector forms the electrical interface. There is no shaft extension on side B, so installation depth remains predictable. The side-mounted connector arrangement can also help keep cable routing clear of nearby moving machine parts.