Product Description:

The MDD071A-N-030-N2M-095GB1 is a synchronous servo motor manufactured for the MDD Synchronous Motors series. Designed for use with digital drive controllers, it converts modulated inverter current into controlled rotary motion for positioning tables, pick-and-place heads, and light-duty conveyor axes used in industrial automation. The motor belongs to size 071 with length code A, so its short housing fits installations where available machine space is limited. Its synchronous design supports precise speed and position control when paired with a compatible closed-loop drive.

Under continuous stall conditions, the rotor produces 2.2 Nm of torque, which is suitable for holding or slowly indexing loads without overheating. Dynamic operation reaches a nominal speed of 3000 rpm, allowing coordinated motion with other axes on the same drive system. Accurate shaft positioning is delivered through digital servo feedback (DSF), which sends rotor data back to the controller for closed-loop regulation. Mechanical alignment is supported by a 95 mm centering diameter, and power plus feedback conductors exit on side B through a sealed connector. This layout keeps cable routing on one end of the motor and leaves the mounting face unobstructed.

An integrated blocking brake supplies a holding moment of 3.0 Nm when the drive is disabled, helping retain vertical or reciprocating loads at standstill. Position reference across multiple revolutions is provided by an integrated multiturn absolute encoder, so the drive can recover axis position after power is restored without a separate homing routine. The mechanical output uses a plain shaft with a shaft seal to limit contaminant entry and lubricant loss. The motor has no shaft end on side B, which keeps the rear section compact and avoids a protruding extension on the cable side.