Product Description:

The MDD065D-N-060-N2M-095PL1 is a synchronous servo unit from the MDD Synchronous Motors series produced by Bosch Rexroth Indramat. Built for digital drive controllers, it converts electrical commands into precise rotary motion for speed-controlled and position-controlled machinery. It is used on assembly lines, packaging stations, and other equipment that requires closed-loop axis control. The motor is suited to applications that need accurate response during repeated starts, stops, and speed changes.

At its rated operating point, the rotor reaches 6000 rpm, supporting short cycle times in high-throughput stations. A continuous standstill torque of 2.7 Nm allows the shaft to hold a load without thermal overload during static holding tasks. The housing uses a 95 mm pilot for straightforward flange alignment. Power and feedback conductors exit on the left side through a sealed connector, which helps routing in compact cabinets. An integrated multi-turn absolute encoder supplies position data across many revolutions, so the drive can restore position information after power returns. Standard dynamic balancing helps reduce vibration during operation, and the 065 frame keeps rotor inertia low.

A blocking brake provides 3.0 Nm of holding torque to secure vertical or suspended loads when the inverter is disabled. The output shaft has a keyway for common couplings, and a shaft seal helps retain lubricant while limiting splash ingress. Command loops use digital servo feedback (DSF) for high-resolution current control in compatible Rexroth drives. The motor uses length code D for added active stack depth, and the single-ended shaft layout avoids an extra shaft extension on side B. A standard housing and connectorized power interface support installation where compact servo motor packaging is required.