Product Description:

The MDD065D-N-060-N2M-095PL0 is a synchronous motor built by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Intended for use with digital drive controllers, it converts regulated current into precise rotary motion for positioning and conveyor duties in automated equipment. As a three-phase, permanent-magnet design, it mounts directly to machine frames and supports fast response in industrial automation. This layout allows the motor to serve as a compact rotary actuator in systems that require repeatable motion and stable servo behavior during frequent start-stop cycles.

A centering diameter of 95 mm provides a concentric fit to the driven assembly. Power and feedback leads exit on the left side through a sealed connector, which helps keep cable routing orderly in enclosed machine spaces. At standstill, the rotor delivers 2.7 Nm of continuous torque, allowing accurate holding without overheating. Under rated excitation, the winding sustains a nominal speed of 6000 rpm, which supports high cycle rates when paired with a suitable inverter. Position is captured by an integrated multi-turn absolute encoder, and its signals are transmitted to the controller as Digital servo feedback (DSF) for tight velocity and position loops. This feedback arrangement helps the control system retain accurate position information after a restart without relying on repeated homing moves.

The motor uses a standard stator housing, and size code 065 with length code D gives the active stack used for this frame. The single shaft end follows a standard profile without a side-B extension and is machined with a keyway for positive torque transfer. A durable shaft seal limits dust and fluid ingress along the output journal. The motor is supplied without a blocking brake, so any holding function must come from the drive or from external machine hardware. This arrangement keeps the rotor assembly simpler and suits applications that do not require an onboard brake.