Product Description:

The MDD065D-N-060-N2L-095GR1 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it is used in industrial automation for rapid position and velocity control on packaging lines, robotics, and material-handling axes. The unit works with compatible drive amplifiers to convert command signals into mechanical rotation, supplying compact torque density for applications that require precise closed-loop motion. Its operating concept suits axes that must accelerate quickly and stop accurately under changing loads.

At its nominal speed of 6000 rpm, the rotor delivers continuous mechanical power while remaining within the thermal limits of the standard aluminum housing. When the shaft is locked, the motor can sustain 2.7 Nm of torque without overheating, supported by its 065 frame size and D length code, which increase active iron. An integrated blocking brake provides 3.0 Nm, so vertical loads can remain stationary when power is removed. Position data is exchanged through digital servo feedback (DSF), enabling the controller to correct deviation within one commutation cycle. All power and signal conductors exit on the right side, which helps when motors are mounted in close proximity.

Installation is guided by the centering pilot of 95 mm, and standard balancing limits residual vibration to protect duplex bearings during high-speed operation. The output uses a plain shaft with a standard side A shaft end only, so it can connect directly to couplings or pulleys. A connector interface simplifies cable connection because hard-wired glands are not required. The motor is supplied with shaft seal, which helps keep splash away from the internal laminations. The standard housing maintains IP protection in lightly contaminated air.