MDD065D-N-040-N2M-095PL1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MDD065D-N-040-N2M-095PL1 is part of the MDD Synchronous Motors series and is designed for use with digital drive controllers. This motor has a continuous torque at standstill of 2.7 Nm, a nominal speed of 4000 rpm, and comes with a keyway shaft type and integrated multiturn absolute encoder. It features a 95 mm centering diameter, a connector-type electrical connection on the left side, and is equipped with a blocking brake providing a holding brake torque of 3.0 Nm.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MDD065D-N-040-N2M-095PL1 belongs to the MDD Synchronous Motors series produced by Bosch Rexroth Indramat. It is a motor for digital drive controllers intended to deliver precise velocity and position control in automated assembly stations, packaging lines, and material-handling axes. The motor has size 065 and a D frame length, which gives it a deeper active magnetic stack within the standard housing. A standard balancing grade reduces vibration during high-speed duty, and the shaft is supplied in a single-ended configuration with no second shaft extension. Because it is intended for digital drive controllers, current regulation and closed-loop motion control are handled by the matched drive system. This arrangement supports precise response during repeated start-stop cycles.
The motor reaches a nominal speed of 4000 rpm, indicating the maximum continuous rotational velocity available when the drive supplies rated current and voltage. At standstill, it can produce 2.7 Nm of continuous torque, allowing the axis to support static loads without overheating. A centering diameter of 95 mm provides the pilot fit for mounting to gearboxes or machine plates and helps maintain concentric alignment. This pilot fit helps the motor seat accurately against machine flanges and couplings. Power and feedback leads exit on the left side, and a factory-installed connector provides the electrical connection. This cable arrangement can keep the electrical interface accessible when the motor is installed in compact machine spaces.
An integrated blocking brake supplies 3.0 Nm of holding torque, securing vertical or indexing loads whenever the drive is disabled. This brake holds the shaft when motion must be prevented after the drive is turned off. Position information is carried through digital servo feedback from an integrated multiturn absolute encoder, so the controller can track shaft position through repeated revolutions. Mechanical power is transmitted through a keyway in the shaft, and a shaft seal helps limit the entry of dust or lubricants into the bearing chamber. The brake and feedback devices are built into the motor housing, which helps keep the installation compact.
Frequently Asked Questions about MDD065D-N-040-N2M-095PL1:
Q: What is the nominal speed of the MDD065D-N-040-N2M-095PL1 motor?
A: This motor has a nominal speed of 4000 min⁻¹.
Q: What type of encoder does the MDD065D-N-040-N2M-095PL1 use?
A: The MDD065D-N-040-N2M-095PL1 includes an integrated multiturn absolute encoder for precise feedback.
Q: Does the MDD065D-N-040-N2M-095PL1 motor have a holding brake?
A: This model is equipped with a blocking brake providing a holding brake torque of 3.0 Nm.
Q: What is the direction and type of electrical connection for the MDD065D-N-040-N2M-095PL1?
A: The connection on this motor is positioned on the left and uses a standard connector.
Q: What kind of shaft is featured on the MDD065D-N-040-N2M-095PL1 motor?
A: The shaft type is a keyway with a shaft seal for added protection.
