Product Description:

The MDD065C-N-060-N2M-095GL1 synchronous servo motor is produced by Bosch Rexroth Indramat and belongs to the MDD Synchronous Motors series. Intended for pairing with digital drive controllers, it converts commanded current into tightly regulated rotary motion that supports indexing tables, compact gantry axes, and other precision automation stages where high acceleration and limited footprint are required. It uses a 95 mm centering register on the flange for accurate mounting on the machine interface.

This motor reaches a nominal speed of 6000 rpm, enabling fast cycle times in equipment that must reverse or settle quickly. At standstill, it can deliver a continuous torque of 2.1 Nm, which is the load the axis can hold without overheating when the shaft is locked by servo action alone. A dedicated blocking brake supplies an additional 3.0 Nm of mechanical holding force, so power-off position retention is possible on vertical or safety-critical axes. All electrical terminations exit to the machine’s service side because the connector faces left, which can simplify cable routing where access is limited.

Position information is generated by an integrated multi-turn absolute encoder, allowing the controller to recover shaft angle after power cycles without external homing sequences. Feedback signals are transmitted as digital servo feedback (DSF), which provides high update rates for closed-loop torque and velocity regulation. The output is a plain shaft with an integral shaft seal that protects the internal bearings from contamination. Overall mechanical length follows code C, giving a slightly extended stator stack that improves continuous output while keeping the 065 frame size unchanged. Standard dynamic balancing of the rotor minimizes vibration at high speed in multi-axis assemblies and supports smooth operation during repeated motion cycles.