Product Description:

The MDD065C-N-060-N2M-095GA1 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Installed alongside digital drive controllers, the unit converts commanded electrical power into precise rotary motion for positioning tables, pick-and-place actuators, and similar automation axes. As a motor for digital drive controllers, it is sized and wired for closed-loop operation with the manufacturer's DSF feedback protocol, which supports accurate and repeatable axis movement.

The motor delivers a continuous standstill torque of 2.1 Nm, allowing it to hold a static load without excess heating when energized. During motion, it can reach a nominal mechanical speed of 6000 rpm, which suits compact rotary axes that require fast cycle times. An internal blocking brake supplies 3.0 Nm of locking torque, keeping vertical or suspended loads secure whenever the power stage is disabled. Rotor position is tracked by the integrated multi-turn absolute encoder, and the resulting data is transmitted through the built-in digital servo feedback interface for tight velocity control. Cabling exits the stator on side A, which keeps connector orientation consistent in multi-axis frames.

Mechanical fitment uses a centering pilot of 95 mm, and the rotor is balanced to a standard grade to minimize vibration throughout the speed range. The motor has a shaft seal that guards the plain output shaft against coolant or dust intrusion, while the standard housing keeps the familiar footprint used on other MDD units. Overall body dimensions correspond to motor size 065 and the extended stack denoted by length code C. A single connector handles power, brake, and feedback conductors, and the plain shaft is supplied without a side-B extension for direct coupling to gearboxes or timing pulleys.