Product Description:

The MDD065C-N-040-N2M-095GL0 is a servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts drive current into controlled torque and speed for axes that require rapid, repeatable motion in automated machinery. The housing follows the standard design used across the series, which supports consistent mechanical integration in machine frames and enclosures. This type of motor is commonly used on feed axes, handling units, and compact positioning systems where stable response and repeatable motion are required throughout frequent start-stop cycles. Standard rotor balancing helps reduce residual vibration during high-speed operation.

The motor has a centering diameter of 95 mm, which seats the stator precisely in the machine wall. It can sustain a continuous standstill torque of 2.1 Nm, allowing the rotor to hold load at zero speed without exceeding thermal limits during continuous operation. The nominal speed is 4000 rpm, which suits applications that require quick indexing cycles. All electrical terminations exit through a left-side connection and use a single circular connector for simplified cable routing. Its compact housing helps it fit tightly spaced machine assemblies without sacrificing precise alignment at the mounting face. The front bearing area includes a shaft seal to help prevent lubricant migration toward the feedback components.

The motor has size code 065 and length designation C, which correspond to its frame and installed stack length. Position data are provided by an integrated multiturn absolute encoder, allowing the drive to recover rotor angle immediately after power is restored. It is supplied without a blocking brake, so holding torque must be provided by the drive or by an external clamp when the axis is stopped. The shaft uses a plain side-A configuration and does not include a side-B extension. That shaft arrangement supports direct coupling to compatible transmission elements while keeping the non-drive end mechanically simple.