Product Description:

The MDD065C-N-040-N2L-095PR1 is a synchronous servo motor manufactured by Bosch Rexroth Indramat and assigned to the MDD Synchronous Motors series. Designed as a motor for digital drive controllers, it converts three-phase electrical energy into regulated torque and speed so indexing tables, pick-and-place modules, and auxiliary spindles can follow programmed trajectories. Integrated motor feedback permits the drive controller to verify rotor position without external encoders, helping reduce cabling complexity in tightly packed automation cells.

Its centering diameter of 95 mm provides a precise flange reference, and standard balancing allows direct coupling to light transmission elements. Power and feedback leads exit on the right side through a single connector, which helps keep cable routing orderly. The unit supplies 2.1 Nm of continuous stall torque, while a nominal speed ceiling of 4000 rpm supports rapid traverse moves on short cycles. Position data is generated by digital servo feedback, supporting high-resolution closed-loop control. A standard housing encloses an internal shaft seal to block lubricant migration, and the shaft end is provided only on side A. The connection uses a plug-in connector for simple cable attachment, and a blocking brake is included to secure the load when power is removed.

The brake can hold up to 3.0 Nm of static torque, making it suitable for vertical or jerk-prone axes within this power range. The motor has size code 065 and length code C, yielding a compact body that minimizes mass while preserving thermal capacity. The output uses a keyway shaft, which resists slip under frequent acceleration and aligns easily with standard pulleys. Low vibration is maintained across the speed range because the rotating assembly is balanced to the standard grade, supporting bearing life and consistent surface finish on processed workpieces.