Product Description:

The MDD065C-N-040-N2L-095PL1 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is intended to pair with digital drive controllers in automated machinery, material-handling axes, and packaging equipment where rapid speed regulation and precise torque control are required. A keyed shaft end, a connector-based power and feedback interface, and a standard housing support installation in closed-loop drive systems. This arrangement lets the controller regulate acceleration, running speed, and stopping behavior with consistent feedback during repeated machine cycles.

At standstill, the motor can deliver a continuous torque of 2.1 Nm, providing the steady force needed for indexing duties without overheating. During operation, it reaches a nominal speed of 4000 rpm, which suits applications that need moderate to high rotational velocity from a compact frame. Position data is returned through digital servo feedback, enabling the drive to correct positional error within each control cycle. All electrical leads exit through a connection on the left side, which determines cabinet routing and cable strain relief, and accurate mechanical centering is supported by a 95 mm pilot diameter. The motor has length code C, and the shaft is single-ended with no extension on side B.

A mechanical holding brake is fitted, and it clamps the rotor with 3.0 Nm of torque to secure vertical loads whenever power is removed. This brake is useful on axes that must remain secure at a stop after drive power is switched off. Contaminant ingress at the output end is limited because the unit is supplied with a shaft seal. The motor uses frame size 065, which sets the mounting dimensions for compatible machine interfaces. The rotor uses Standard balancing, which helps keep vibration low at rated speed and supports smooth operation.