Product Description:

The MDD065B-N-060-N2M-095GB0 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed for digital drive controllers, it converts controlled three-phase power into precise rotary motion while returning position information to the automation system. That closed-loop behavior makes the motor suitable for compact pick-and-place actuators, indexing tables, and other equipment that depends on repeatable speed and position control. In digital motion systems, the motor can respond quickly to command changes, which helps axes perform short moves, frequent reversals, and consistent stop points.

The unit reaches a nominal speed of 6000 rpm, which supports fast cycle times in light-duty axes. It sustains 1.5 Nm of continuous standstill torque, allowing the shaft to resist modest process loads without overheating. Accurate mechanical centering is provided by a 95 mm pilot diameter on the flange, while standard dynamic balancing helps reduce vibration during rapid acceleration. The frame uses motor size 065 with length code B, which keeps the housing compact for dense machine layouts. Service access is arranged on side B, and both power and feedback conductors terminate in a keyed connector that helps maintain correct phase sequencing and EMC shielding. The motor also uses a plain shaft with the standard end format, and there is no secondary shaft extension on the opposite face.

Position tracking is handled by an integrated multi-turn absolute encoder that retains revolution data through power loss. Its signals reach the controller through digital servo feedback, allowing high-bandwidth current vector regulation and stable control across changing load conditions. The motor is supplied without a blocking brake, so any application that requires static holding must use external load retention or drive-applied torque. Sealing is improved with a shaft seal that helps keep liquid spray and fine debris out of the bearing cavity. This arrangement supports operation in areas where contamination around the shaft opening could otherwise shorten bearing life.