Product Description:

The MDD065B-N-060-N2L-095PL1 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Intended for use with digital drive controllers, it converts commanded electrical energy into precise rotary motion for automated positioning and speed regulation in packaging equipment, pick-and-place stations, and other multi-axis industrial systems. Its compact 065 frame, integrated feedback, and factory-installed blocking brake make it suitable for axes that require repeatable movement and stable holding at standstill. In operation, the motor works with the connected drive to maintain accurate speed and position even during frequent start-stop cycles.

It delivers a continuous standstill torque of 1.5 Nm, allowing the axis to hold load without overheating when stopped. During motion, the rotor can reach 6000 rpm under rated conditions, supporting rapid traverse cycles and short positioning moves. Position and velocity data are returned through digital servo feedback (DSF), enabling closed-loop control by the connected drive and allowing quick correction of motion errors. Cabling exits the motor on the left side, and a single multi-pin connector carries both power and feedback lines for simpler routing in compact machine layouts.

The integrated blocking brake applies up to 3.0 Nm of holding torque to secure vertical axes when power is removed. A centering pilot of 95 mm aligns the flange with machine frames, while the machined keyway on the shaft provides positive coupling to pulleys or gears. A shaft seal helps prevent lubricants or contaminants from migrating along the shaft during operation. The motor also has frame length B, a standard shaft end on side A only, a standard housing, and standard dynamic balancing for compact automation modules that require light inertia and quick acceleration.