Product Description:

The MDD065B-N-060-N2L-095GA1 is a rotary servo motor produced by Bosch Rexroth Indramat. It is intended for use with digital drive controllers within the MDD Synchronous Motors series. It converts electrical command signals into mechanical rotation for positioning, speed, or torque control tasks in automated machinery such as packaging axes or light pick-and-place gantries in compact automation systems, where repeatable motion is needed during frequent starts, stops, and short indexing moves.

The motor belongs to frame size 065 and uses a centering flange with a 95 mm diameter to align the housing during mounting. At standstill it can deliver a continuous torque of 1.5 Nm without exceeding thermal limits during continuous operation. Under rated excitation the rotor can reach a nominal speed of 6000 rpm, allowing high surface velocities on tightly coupled mechanisms. An integrated blocking brake provides 3.0 Nm of holding torque when energized so vertical loads do not drift after power is removed. Standard housing and balancing grades suit typical industrial installations, and the B length code indicates the active stack height within this motor frame.

Digital servo feedback supplies position data to the controller for precise commutation and rapid error correction. Power and feedback plugs face Side A and use a keyed connector arrangement that helps maintain consistent cable orientation. Mechanical power is transmitted through a plain shaft, and a shaft seal helps protect the bearings from splash water and fine dust. The shaft end is limited to the drive side, so couplings can be mounted close to the bearing without interference on the opposite side. With standard balancing, the rotor runs smoothly across the speed range, and the housing remains compatible with forced-air cooling if higher continuous output is required.