Product Description:

The MDD065A-N-060-N2M-095PB0 is a permanent-magnet synchronous motor produced by Bosch Rexroth Indramat as part of the MDD Synchronous Motors series. Designed for use with digital drive controllers, the unit converts electrical power into controlled mechanical rotation needed for pick-and-place modules, small gantries, and indexing tables in automated production lines. Because rotor position is returned to the controller through digital servo feedback, the motor supports closed-loop operation and rapid command execution while maintaining accuracy across its intended speed range.

The motor uses motor size 065, a classification that sets the flange outline and helps match the unit to standardized mounting frames. A centering diameter of 95 mm aligns the stator precisely against the machine surface, and the power and feedback leads exit through a connector interface to simplify cable changes. At its rated operating point, the shaft can reach 6000 rpm, providing high peripheral speed for light-inertia loads, while the continuous standstill torque of 0.8 Nm supports stable holding and low-speed control without thermal overload. All electrical terminations are oriented on side B of the housing so panel layouts remain compact.

Dynamic behavior is aided by standard balancing, which helps minimize vibration at high speed and protects the built-in bearings. Position information is supplied by an integrated multi-turn absolute encoder that records multiple shaft revolutions and feeds the DSF channel to the controller for immediate correction. The compact stator depth uses motor length code A, which helps reduce mass, and a keyway shaft with a standard side-A output simplifies coupling because no opposite-end shaft is present. The shaft is delivered with a shaft seal, which helps keep lubricants inside and airborne contaminants out. The motor uses a standard housing and arrives without a blocking brake, so any holding function during a power-off state must be provided elsewhere in the axis. Digital signals are routed through the designated feedback port.