Product Description:

The MDD065A-N-060-N2M-095GL0 is a synchronous servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts precisely modulated three-phase current into mechanical rotation, making it suitable for pick-and-place units, light gantries, and indexing tables in automated cells. Its electrical commutation and permanent-magnet rotor support high dynamic response in closed-loop systems where consistent velocity and repeatable positioning are important.

At a nominal speed of 6000 rpm, the rotor can reach high surface velocity without exceeding thermal limits, making the motor suitable for short-cycle processes. Its continuous torque at standstill is 0.8 Nm, so the motor can hold that load indefinitely when locked by the control loop. Position feedback is handled by an integrated multi-turn absolute encoder that transmits rotor angle over digital servo feedback (DSF). This arrangement supplies fine resolution and multi-turn tracking, eliminating the need for homing after power loss. A centering pilot of 95 mm aligns the motor housing to mating machine frames and helps minimize radial runout during assembly.

The mechanical interface uses a plain shaft, so torque is transferred through backlash-free couplings rather than keys. Contaminant ingress is restricted by a shaft seal installed around the output journal. Power and feedback leads exit on the left side because the primary connector is located there, which can simplify cable routing along rear-mounted carriages. Standard dynamic balancing limits residual vibration, and the standard housing, motor size 065, and compact length code A help keep mass low for fast acceleration. The unit is supplied without a blocking brake, so applications that require static holding must rely on external clamping or drive torque.