Product Description:

The MDD065A-N-060-N2L-095GR1 is a synchronous AC motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it converts commanded current into repeatable rotary motion for small part handling, labeling, and other automated processes. By combining a permanent-magnet rotor with internal feedback elements, the unit supplies tightly regulated torque and speed so positioning remains accurate when load conditions change. The motor is intended for precise closed-loop operation in applications that need consistent response during repeated starts, stops, and speed changes.

Its continuous torque at standstill is rated at 0.8 Nm, so it can maintain that output continuously without overheating under normal operating conditions. The motor reaches a nominal speed of 6000 rpm, which supports rapid indexing and short machine cycles. Accurate mounting is aided by a centering diameter of 95 mm, which helps align the motor with the mating machine surface. Power and feedback leads exit on the right and terminate through a connector, which keeps electrical hookup compact and orderly. Position data is returned through digital servo feedback (DSF), allowing the drive controller to close the motion loop without an external encoder. The motor also uses a short housing length, which helps it fit into space-limited assemblies while keeping the series housing format.

For holding tasks, an integrated blocking brake delivers 3.0 Nm when power is off. Motion is transmitted through a plain shaft that follows the standard shaft end without a side B extension, which simplifies coupling alignment. A protective shaft seal helps limit the entry of contaminants at the output end. Standard balancing keeps vibration low for frame size code 065, which supports smooth running during operation. The brake is useful where the load must remain in position after power removal, including vertical or suspended axes.