Product Description:

The MDD065A-N-060-N2L-095GL0 is a synchronous AC servo motor manufactured by Bosch Rexroth Indramat and supplied as part of the MDD Synchronous Motors series. Classified as a motor for digital drive controllers, it is installed in compact automation stations where precise rotary motion must be generated and monitored by an external drive. The small-frame unit delivers continuous torque while keeping overall mass low, making it suitable for assembly cells, pick-and-place heads, and light conveyor indexing mechanisms.

The motor size of 065 establishes a moderate 65 mm stator frame that fits tight machine envelopes. Its centering diameter of 95 mm aligns the flange accurately so repeatable runout is maintained after installation. A nominal speed of 6000 rpm allows high cycle rates, and the windings can sustain 0.8 Nm of continuous standstill torque without exceeding thermal limits. Motion feedback is handled by digital servo feedback, letting the drive close position, velocity, and torque loops with a single encoder signal. The housing uses the standard design, and the A length code indicates the shortest rotor stack in this frame, which lowers inertia for rapid moves while preserving the same mounting pattern. A single molded connector provides power and signal terminations.

Because the connections are on the left side, cable routing can follow panel layouts that separate power from low-level I/O. Vibration at operating speed is limited by standard balancing, reducing stress on adjacent bearings. Contamination ingress is blocked by a shaft seal that covers the output end, and torque is delivered through a plain shaft that accepts clamp or compression couplings; a side-B shaft extension is not provided, which helps shorten the overall length. The motor is delivered without a blocking brake, so external clamping or active drive torque must hold vertical loads when power is removed. The connector layout supports modular drive assemblies.