Product Description:

The Bosch Rexroth Indramat MDD065A-N-060-N2L-095GA0 belongs to the MDD Synchronous Motors series and is used with digital drive controllers. Built for compact automation axes, it converts regulated drive current into precise rotary motion for positioning and speed-controlled tasks. The motor uses size 065 with a short A length, which gives it a compact housing for machines with limited mounting depth. Its compact form is useful where several axes must fit into a small machine frame without sacrificing controlled motion quality. The synchronous motor design also supports smooth speed regulation when matched with a compatible controller. In industrial cells, it can serve as the primary rotary element for pick-and-place heads, light packaging spindles, and fast conveyor belts that require closed-loop control and quick response during repeated cycles.

For continuous duty, the rotor provides 0.8 Nm of standstill torque to resist light static loads when the drive holds position. When energized at rated frequency, it reaches a nominal speed of 6000 rpm, which supports high cycle rates without external gearing. Accurate mounting is supported by a 95 mm centering diameter that helps align the motor with common machine plates. Power and feedback leads exit on side A, which can simplify cable routing when one machine edge is used for connections. A plain shaft with a shaft seal helps protect the shaft area from coolant splash and supports direct coupling to pulleys or pinions.

The motor uses a Standard balancing grade, which helps reduce vibration during acceleration and steady operation. Electrical termination is completed through a keyed Connector that provides a fixed connection point for the motor cables. Position data is delivered over integrated Digital servo feedback (DSF), allowing the drive to monitor rotor position and speed for closed-loop regulation. This feedback arrangement also supports repeatable motion because the controller receives continuous rotor information during operation and at standstill. The unit is supplied without a blocking brake, so vertical or suspended loads need an external holding method when power is removed.