Product Description:

The MDD065A-N-040-N2M-095GL0 is a synchronous servo motor from the MDD Synchronous Motors series produced by Bosch Rexroth Indramat. Intended for use with digital drive controllers, this compact unit converts commanded current into precise rotational motion and returns position signals for closed-loop control. It is suitable for automated packaging lines, pick-and-place gantries, and small machining spindles where repeatable positioning and stable speed regulation are required. Because it is designed for servo operation, the paired drive can regulate acceleration and deceleration with consistent response during repeated motion cycles. Its integrated feedback and connectorized cabling support straightforward integration in multi-axis systems.

The motor’s nominal shaft speed is 4000 rpm, allowing high-speed operation in compact servo axes. Under static load, it sustains 0.8 Nm of continuous torque, which is suitable for lightweight actuators during dwell periods. An integrated multiturn absolute encoder captures rotor position over multiple turns and sends this information through digital servo feedback (DSF), allowing accurate position tracking at the drive. This feedback arrangement supports commutation and position control without requiring separate external sensing hardware. Accurate flange alignment is supported by the 95 mm centering diameter, and standard dynamic balancing helps reduce vibration during operation. The motor also uses an A-length housing with a size-065 frame and has no blocking brake, so holding functions must be provided externally.

Electrical and signal interfaces exit on the left side, and the removable connector helps keep cable routing orderly in compact machine layouts. This orientation can be useful where adjacent axes or guarding limit available space around the housing. A shaft seal is fitted at the output end to protect the bearings from coolant splash and fine dust. The output uses a plain shaft and has no side-B extension, which allows direct coupling through clamp hubs or collets. Compact exterior dimensions help the motor fit into tight installation spaces, and the short stator keeps mass low for rapid start-stop duty cycles.