Product Description:

The MDD065A-N-040-N2L-095GA0 is a synchronous servo motor produced by Bosch Rexroth Indramat for the MDD Synchronous Motors series. It is designed as a compact rotary actuator for use with digital drive controllers in automated machinery. The motor converts commanded current into precise torque and speed for positioning tasks that require repeatable motion. It is well suited to compact axes where accurate response and short cycle times are important.

At standstill, the motor delivers a continuous torque of 0.8 Nm, which is suitable for light feed axes that must hold load without motion. Its base speed is rated at 4000 rpm, allowing rapid cycle times when the drive operates at full command speed. Accurate mechanical alignment is aided by a 95 mm centering diameter that matches standard flange patterns. Power and feedback are routed through a single connector on side A, which helps simplify cable routing in compact cabinets. The rotor is balanced to the standard grade so vibration remains within the limits of typical machine frames. An integrated shaft seal helps block coolant or dust ingress, and the motor operates as a unit for digital drive controllers with commutation managed by the drive rather than by internal electronics.

The feedback channel uses digital servo feedback, so the drive receives high-resolution position data without analog drift. The model is supplied without a blocking brake, so an external clamp is needed only when vertical holding is required. Its physical envelope follows motor size 065, and the compact A length helps keep inertia low in pick-and-place modules. A plain shaft with a factory-installed seal supports direct coupling without keyways while still resisting lubricant entry. The shaft is provided only on the drive side, which keeps the overall length short and allows the rear face to sit flush against machine bulkheads.