Product Description:

The MDD041C-N-100-N2K-050GA1 is a three-phase permanent-magnet servo motor manufactured by Bosch Rexroth Indramat for the MDD Synchronous Motors series. Designed to work with digital drive controllers, it converts commanded current loops into precise rotary motion for pick-and-place gantries, compact conveyors, and light machining spindles. By translating drive currents into rapid, repeatable shaft movement, it supports higher throughput and tighter tolerances across automated production cells.

Thermal and dynamic capability begin with a continuous stall output of 2.05 Nm, allowing the axis to hold load without overheating. When acceleration is commanded, the rotor reaches a nominal speed of 10000 min⁻¹, suiting high feed-rate applications. Cabling is straightforward because power and signal leads exit on Side A, and a keyed Connector permits quick replacement during maintenance. Position reference is retained across power cycles by an Integrated absolute encoder, minimizing homing time after shutdowns and simplifying recovery sequences.

Additional hardware safeguards long-term reliability. A blocking brake rated at 1.2 Nm locks the shaft when the controller is disabled, preventing drift on vertical or overhung loads. Mounting accuracy is ensured by the 50 mm centering diameter, while standard balancing keeps vibration low at speed. For noise-immune signaling the motor provides Resolver feedback, complementing the encoder with analog sine-cosine traces. A sealed, Plain shaft combines a factory shaft seal, standard housing, motor length code C, size 041 geometry, and a single-ended shaft end so the rear remains clear for tight machine layouts.

Wake Industrial can arrange same-day shipping when schedules are tight. International shipping options are available to facilities outside the United States. For budgeting convenience, every written quote remains valid for 30 days.