Product Description:

The MDD041C-N-100-N2G-050FA0 is a synchronous servo motor produced by Bosch Rexroth Indramat within the MDD Synchronous Motors series. As a motor for digital drive controllers, it converts commanded current into precise mechanical rotation for positioning and velocity loops common in printing, packaging, and small handling axes. The unit belongs to motor size 041 and carries a C length code, giving it a compact envelope for tight machine frames while maintaining the speed needed for high-throughput automation. Its synchronous design supports accurate speed regulation when paired with a compatible servo controller.

It delivers a nominal speed of 10000 rpm, allowing the rotor to support rapid indexing cycles under rated conditions. At standstill, the motor sustains 2.05 Nm of continuous torque for fine incremental moves without overheating. A centering pilot of 50 mm simplifies concentric mounting and helps minimize radial runout at the machine interface. Electrical and feedback connections exit on Side A, and power is routed through a connector interface. Motion feedback is obtained from resolver feedback, which provides rotor position data with high noise immunity. Standard dynamic balancing and the standard housing support smooth running and stable thermal behavior during normal operation.

The mechanical output is provided through a plain shaft, which is intended for coupling by an external hub or clamping element. The motor is supplied without a shaft seal, so the application must prevent coolant or oil ingress at the coupling. It is also supplied without a blocking brake, so an external holding method is required when torque must be maintained after power is removed. The drive end uses a standard single-ended shaft arrangement, and there is no secondary shaft on side B. This layout helps keep rotating mass low for quick acceleration in multi-axis gantries.