Product Description:

The MDD041A-N-100-N2K-050PB0 belongs to the MDD Synchronous Motors series manufactured by Bosch Rexroth Indramat. As a motor for digital drive controllers, it delivers rapid, precise rotary motion to axes that require tight velocity loops inside compact automation cells. Size 041 hardware with length code A keeps the assembly short so it can be fitted into narrow mechanical frames, while standard housing and balancing simplify interchange with earlier MDD units.

At standstill the shaft can provide a continuous torque of 0.64 Nm, and when energized by a matched controller the rotor accelerates to a nominal speed of 10000 min⁻¹ for high-cycle positioning. Installation is centered on a 50 mm locating pilot that assures coaxial alignment with gearheads or couplings. The motor size code 041 defines the stator stack diameter, and length code A indicates the shortest stator section available in the series, keeping inertia low for fast response. A shaft seal is fitted to limit lubricant migration, and the keyway machined on the shaft enables rigid torque transfer to pulleys or pinions.

Cabling exits on the machine’s non-drive face via the Side B connector arrangement; power and feedback are passed through a single industrial Connector so panel wiring is minimized. Position feedback is supplied by Resolver feedback for robust angle detection across the full speed range, while an Integrated absolute encoder captures multiturn position data for sequence recovery after power loss. The unit is delivered without a blocking brake, uses standard housing and balancing, and includes a standard shaft end on the drive side only.

Wake Industrial stocks this motor and can arrange same-day shipping for time-critical orders. Every purchase carries a 1-year warranty. Quotations remain valid for 30 days so planning and approval cycles are protected.