Product Description:

The MDD025C-N-100-N2G-040GE1 is a synchronous motor manufactured by Bosch Rexroth Indramat and grouped in the MDD Synchronous Motors series. The unit is identified as a motor for digital drive controllers, so it mates directly with the company’s drives to deliver controlled rotary motion inside automated equipment. Its compact build and high nominal speed allow it to actuate light mechanical loads in indexing tables, pick-and-place heads, and other rapid-cycle axes frequently found in assembly and test cells.

At the mechanical level the motor supplies a continuous standstill torque of 0.90 Nm, defining the load it can hold without rotation while current stays within its continuous rating. During operation the rotor reaches a nominal speed of 10000 min⁻¹, making the device suitable for high-throughput cycles when paired with a matched controller. Position data is generated through Resolver feedback, supplying sine-cosine signals that the drive converts to absolute angle even during rapid acceleration. Power and signal conductors exit on the Left side, and they are combined in a Connecting cable with coupling unit that simplifies cabinet wiring and exchange.

Dynamic holding tasks are supported by an integrated blocking brake delivering 1.0 Nm of torque, so the shaft can lock during power-off events. The flange’s centering pilot measures 40 mm, allowing direct alignment with gearboxes or couplings that share this register. A Plain shaft is supplied without a side-B end and is protected by a shaft seal to limit lubricant migration. The motor follows a Standard balancing grade and fits the 025 frame with length code C, resulting in a compact envelope while maintaining thermal conduction inside the Standard housing. Classified as a Motor for digital drive controllers, it couples to the drive over resolver channels without needing extra sensors.