Product Description:

Bosch Rexroth Indramat manufactures the MDD025C-N-100-N2G-040FB0 servo motor for use with digital drive controllers in automated production equipment. As a member of the MDD Synchronous Motors series, it supplies torque directly to light-duty axes that demand rapid acceleration and repeatable high-speed rotation. By integrating with a drive, the unit converts controlled three-phase current into rotary motion, supporting accurate velocity and position loops in packaging stations, pick-and-place heads, or small tool spindles.

The mechanical interface is fixed by a centering diameter of 40 mm, and the rotor is balanced to the standard class to minimize residual vibration at its rated velocity. Power and feedback terminations exit on Side B, and a single industrial Connector simplifies cabling within cramped cabinets. When held stationary, the motor can deliver a continuous torque of 0.90 Nm; this value guides sizing for vertical loads or tensioning rolls that remain energized for long intervals. Under dynamic operation the shaft can reach a nominal speed of 10000 min⁻¹, allowing short cycle times in indexing mechanisms. A standard aluminum housing promotes heat dissipation, and the frame follows the 025 size code that indicates a compact outer diameter compatible with small mounting plates.

Position information is returned through resolver feedback, enabling absolute angle detection even during rapid reversals. The model is supplied without a blocking brake, so holding torque must be provided by the drive or an external locking device when power is removed. Its geometry is specified as a plain shaft, and the design omits a shaft on the rear side, consistent with the standard shaft-end configuration. Because it ships without a shaft seal, the installation area should be protected from coolant splash or conductive dust. Finally, the overall length matches code C, completing a compact package that fits inside narrow Z-axes while preserving the standard housing outline.