Product Description:

The MDD025A-N-100-N2K-040GA1 is a compact AC servo motor manufactured by Bosch Rexroth Indramat within the MDD Synchronous Motors series. Designed for use with digital drive controllers, it converts regulated current into precise rotary motion for pick-and-place axes, feeders, and labeling heads. The motor employs permanent-magnet excitation, and its standard housing and balancing allow direct installation in tight automation frames without supplemental vibration dampers. A built-in resolver and blocking brake let the unit report position and secure loads during power loss.

Its continuous torque at standstill is 0.33 Nm; this specifies the maximum static load the windings can sustain without overheating. The rotor reaches a nominal speed of 10000 min⁻¹, enabling short indexing times on low-inertia mechanisms. Cabling exits on Side A to streamline routing alongside articulated carriers, and a concentric pilot of 40 mm centers the flange against gearheads. Position data is supplied by the Integrated absolute encoder, allowing the controller to recover multiturn position immediately after a power cycle.

The integrated brake develops 1.0 Nm of holding torque, preventing axial drift on light vertical axes when the drive is disabled. A Plain shaft interface mates easily with clamp couplings, eliminating the need for keyed assemblies. The resolver-based Resolver feedback channel delivers analog phase information even if encoder communication is interrupted. Contaminants are excluded by a housing supplied With shaft seal, supporting reliable service in filling lines, cartoners, and other equipment where splash or dust is expected.

Wake Industrial stocks this model and can arrange same-day shipping when timelines are tight. Quotations for the motor remain valid for 30 days, simplifying approval workflows. A free chat tool is available for general questions about type codes or error messages.