Product Description:

The MCP070F-V050-NI-N0CN-NNL5 is an ironless linear motor primary section produced for the MCP Linear Motors series. As a moving coil unit, it generates direct linear thrust when energized by a compatible drive, eliminating mechanical gear reductions. In industrial automation, the motor slides along a fixed magnet track to position tooling, pick-and-place carriages, or metrology payloads with low cogging and high dynamic accuracy over repeated cycles.

Its electrical interface is designed for a DC link of 300 VDC, a voltage level common to multi-axis motion platforms so that several axes can share the same power supply bus. The coil set is built to the compact 070 frame size, matching carriages where space is limited while still delivering adequate continuous force density. Installation is simplified by the front cable exit because the flex conduit can be routed alongside the carriage without adding height to the assembly. Thermal management relies on natural convection, so heat is dissipated to the surrounding air through the aluminum carrier without external fans or liquid circuits. Mechanical attachment uses an I-shaped mounting pattern, allowing the coil to bolt directly to standardized linear bearings without custom adapter plates.

A coil stack length code of F extends the active copper section, increasing continuous thrust capability for long-stroke axes that must accelerate payloads rapidly. Classified as an MCP ironless linear motor, the unit has no iron in the mover, so detent forces are minimal and velocity ripple is reduced during servo control. That behavior supports smooth travel in positioning systems that require fine path control and quick direction changes. It is intended for use with matching drives and feedback scales so the axis can reach the required force profile while staying within the thermal limits of this frame length.