Product Description:

The MCP040B-V300-NI-L0CN-NNNN linear motor is produced by Bosch Rexroth Indramat within the MCP Linear Motors series. It functions as the active mover in an ironless direct-drive system, generating thrust along a permanent-magnet secondary track without rotary conversions, gear reduction, or ball-screw mechanisms. By removing iron from the primary, the design minimizes cogging forces so motion controllers can hold smooth velocity profiles during high-precision positioning and rapid pick-and-place tasks in automated machinery that demands repeatable motion.

This model routes its power and feedback leads toward the load from the front, an arrangement that keeps the cable bundle inside the travel envelope and prevents looping outside the machine frame. Heat generated by the windings is dissipated through natural convection; no liquid channels or forced-air ducts are required, simplifying installation and leaving the moving axis free of auxiliary cooling hardware. The electromagnetic circuit is energized from a 300 VDC bus, matching mid-range servo drive platforms that share the same intermediate circuit. Its frame length is coded as B, indicating an active coil stack sized for moderate continuous force while keeping the mass low. Commutation and phase alignment are handled by a Hall unit that provides a digital output, allowing the drive to read coarse position information during startup without relying solely on higher-resolution feedback.

The primary body corresponds to motor size 040, so its cross-section is optimized for narrow carriages and lightweight gantry axes. Mechanical attachment follows an I-shape mounting profile that bolts directly to matching Rexroth secondary rails without spacer plates or adapters. The unit is classified as an MCP Ironless Linear Motor, placing it among ironless coils with the same cooling approach and similar electrical behavior. The motor is supplied without factory-installed special options such as protective shrouds or custom cable lengths.