Product Description:

The MCP040B-V070-NI-L1CN-NNNN linear motor is part of the MCP Linear Motors series produced by Bosch Rexroth Indramat. It acts as the moving coil segment in a direct-drive linear setup, supplying controllable thrust along a magnet track and eliminating gearboxes or ball screws. This structure minimizes mechanical wear and permits accurate velocity and position regulation, making the unit suitable for semiconductor handlers, packaging lines, and measurement platforms where smooth, cog-free motion is critical to product quality and cycle time.

Its electromagnetic circuit is designed for a 300 VDC bus, so the accompanying drive must maintain that voltage level to reach the rated force constant and acceleration profile. Heat produced by copper losses is removed through natural convection, letting the motor operate without liquid or forced-air aids, which simplifies carriage design. With the compact 040 frame size, the moving mass stays low, supporting high dynamic response on lightweight gantries. The Hall unit provides analog output signals that the controller interpolates for commutation and position tracking over the full stroke. These characteristics align with the build philosophy of Bosch Rexroth Indramat, where reduced cabling and low heat dissipation ease machine integration.

Installation parameters further define the mechanical interface. An I-shape mounting style concentrates the coil’s active width so it fits narrow guide rails while still aligning precisely with the permanent-magnet track. Service access is simplified because the wiring emerges through a front cable exit, preventing loops that could rub against adjacent axes. The mover length follows frame length code B, giving an active coil stack long enough to support thrust overlap on typical platen pole pitches.