Product Description:

The Bosch Rexroth Indramat MAF225C-0150-FQ-M2-FF0-35-N1 is an asynchronous motor in the MAF IndraDyn Asynchronous Motors series. It converts inverter-fed three-phase power into steady shaft torque for conveyors, extruders, and forming machines that require compact motor integration and stable thermal behavior. This liquid-cooled housing motor is suited for high-duty industrial operation where consistent output and controlled heating are important during long run times. Its design supports direct use in machinery that depends on reliable continuous motion without excessive external cooling hardware.

The motor is rated for 1500 rpm, and heat is removed by liquid cooling through a 1/2-inch connection thread built into the housing. This closed-loop arrangement helps the size 225, length C frame sustain continuous load with controlled temperature rise. Position feedback is transmitted over an EnDat2.1 channel, and a 2048-increment disk inside the multi-turn encoder supplies high-resolution angle data. The rotor uses a plain shaft with a labyrinth seal and standard bearings for dependable operation in driven systems. The motor does not include a holding brake, so stopping torque must be supplied by the drive, while vibration remains within level A according to DIN EN 60034-14. Sealing to IP65 helps keep out dust and low-pressure water spray during washdown.

The motor supports flange and foot mounting, allowing face alignment at the drive point while also supporting the assembly on a machine base. Electrical insulation is rated to class F when the surrounding air remains within 0–40 °C. The integrated multi-turn encoder operates from a 7–12 V supply and retains absolute position after power cycles, which removes the need for a homing move at startup. Coolant circulation helps keep internal temperatures below insulation limits during continuous duty. The motor can be mounted directly to gearboxes, belt stages, or other driven loads where stable speed feedback and compact installation are required.