Product Description:

The MAF180D-0200-FQ-S2-DH0-35-V1 is an asynchronous housing motor manufactured by Bosch Rexroth Indramat as part of the MAF IndraDyn Asynchronous Motors series. It combines liquid-cooled operation with flange and foot mounting, so it can be installed on compact machine frames or base plates. In automation systems, the motor converts electrical energy into rotary motion for conveyor drives, extruders, and forming machines that run for long periods under steady load. Its enclosed design supports continuous-duty applications where stable thermal behavior is important to overall machine performance.

This motor reaches a rated speed of 2000 rpm, allowing line shafts or gear stages to operate at moderate mechanical speeds without overspeeding the rotor. The housing is sealed to IP65, which helps protect internal windings from dust ingress and water jets. It uses reinforced bearings to carry radial loads from belt tension. Heat is removed through liquid cooling, and the cooling jacket uses a 1/2 inch connection thread that matches common fittings. The thread is located on the right-side terminal box, which can be rotated to simplify cable routing in confined machine layouts.

Feedback is provided through an encoder system that uses the EnDat2.1 serial interface. The single-turn absolute sensor resolves shaft position into 2048 increments, and it operates from a stabilization supply of 7–12 V, matching common drive controllers without additional signal conditioning. The motor is supplied without a holding brake and without a shaft sealing ring, so external locking or protective measures are required when static load retention or an oil barrier is needed. Vibration level A, insulation class F, and compliance with DIN EN 60034-14 support operation in ambient temperatures from 0 to 40 °C. These characteristics make the motor suitable for industrial systems that need accurate position feedback and controlled thermal performance.