Product Description:

The MAF180D-0150-FQ-S2-HP0-35-V1 is a liquid-cooled asynchronous housing motor produced by Bosch Rexroth Indramat for the MAF IndraDyn Asynchronous Motors series. Designed for integration into machine tools, presses, and automated transfer lines, the unit converts drive power into precisely regulated rotary motion that can be commanded by an inverter. Its liquid jacket removes heat directly from the stator, so the motor maintains rated output even when it is installed inside sealed enclosures with limited airflow. Integrated feedback electronics allow the drive controller to synchronize speed and position with minimal delay.

Thermal management is handled by liquid cooling circulating through an internal jacket that is accessed via a connection thread; the port accepts a 1/2 inch coupling, allowing quick tie-in to plant chillers. Reinforced bearings support higher radial forces, while frame size 180 and length code D set the mechanical envelope. Rated speed is 1500 rpm, and vibration level A is maintained when the motor is secured with flange and foot mounting. Electrical feed enters on the B-side through a rotatable terminal box, simplifying conduit routing. Protection rated to IP65 is achieved with a shaft sealing ring and a keyway shaft, so splash water and dust do not reach the windings. Compliance with DIN EN 60034-14 governs balancing and noise.

Position feedback is supplied by a single-turn absolute encoder that communicates through EnDat2.1 and delivers 2048 increments per revolution while being powered from 7–12 V. The rotor is balanced with a complete key, so coupling components remain within tolerance after shaft locking. Insulation class F permits higher internal temperatures, and safe operation is specified from 0–40 °C ambient. Winding code 0150 is used for this speed range. The unit is shipped without a holding brake, reducing length and inertia but requiring external holding methods during power loss.