Product Description:

The MAF180D-0100-FQ-S2-KH0-35-N3 belongs to the MAF IndraDyn Asynchronous Motors series produced by Bosch Rexroth Indramat. It is a liquid-cooled asynchronous housing motor built for industrial automation tasks that require continuous torque in confined cabinets. As a housing motor, it interfaces directly with drives and gear stages to move conveyors, extruders, or test stands where heat is removed through the motor jacket. The enclosed design also suits installations where moving air inside the cabinet must be minimized.

The stator is thermally stabilized by liquid cooling routed through a 1/2-inch connection thread, eliminating external fan noise and permitting full torque at the rated speed of 1000 rpm. Mechanical attachment is flexible because the casing supports flange and foot mounting, allowing the motor to be anchored either to a baseplate or to a machine wall. The enclosure carries an ingress rating of IP65, so dust deposits and low-pressure water jets cannot reach the windings. Position feedback is supplied through a digital EnDat2.1 interface that transmits absolute rotor data each cycle, and the integrated single-turn encoder generates 2048 increments per revolution to support fine closed-loop speed control.

The encoder electronics operate from 7–12 V, allowing standard low-voltage supplies inside the cabinet. The insulation system is rated to Class F, which tolerates winding temperatures up to 155 °C before degradation. Rotor balance meets vibration level B, which is suitable for rigid couplings on precision gearboxes. The motor uses standard bearings, a plain shaft without a shaft sealing ring, and no holding brake, so external clamping is required for zero-speed load support. Frame size 180 with length code D and winding code 0100 set the motor envelope, and compliance with DIN EN 60034-14 supports consistent mounting tolerances. Operation is intended for ambient temperatures between 0 and 40 °C.